Meet The Required Chemical Levels
The water quality in your pool should be at a neutral pH and chlorine levels, which are required by most cities. To reduce the level of chemicals from high to safe ranges, stop adding any more chemicals into the water for at least a few days.
Another alternative would be using chlorine neutralizers to speed up how quickly they will reach the necessary levels for you to safely drain your pool water.
If you dont have any idea about the required chemical levels where you live, its best to reach out to the local water authority in your area.
Potential Legal Implications Involved In Draining A Pool
Draining your swimming pool in the street, storm drains, around waterways, or on public property is illegal widely. Unless you specifically know the laws of your region and draining pools publicly is permitted, you risk legal repercussions and fines for doing so.
Anytime that you drain a pool, you run the risk of flooding your property, as well as your neighbors. Pay heed to proper draining techniques and use the sanitary sewer line outside your home to be safe. While it takes a bit longer to drain properly, it ensures you dont incur fines or costly damage in the process.
Also Check: How To Vacuum Intex Above Ground Pool
Do What You Need To Do
If you drained the pool to fix the chemical balance, immediately proceed to these next steps. If you have work to dosuch as repairing or painting your poolgo ahead and do that now. In the rare case that you need a totally dry floor to work, use a heavy-duty and durable cover pump like the Sunnora 1500 GPH Pool Cover Pump. And as soon as youre ableand in no more than one weekproceed to these next steps to refill your pool.
Recommended Reading: How To Make Sinuses Drain
Can I Drain My Pool Water Into The Street
In simple terms, you cannot drain pool water into the streets, curbs, catch basins, gutter, ditches, channels, and ultimately, into storm drains. The purpose of the storm drain is to quickly remove rain water from the ground. In order to drain a storm drain, the water must first be pumped out of the drain. This is done by a pump, which is a device that uses water pressure to force water through a pipe.
The pump is usually located in the basement or crawl space of a building, but can also be located on the roof of an apartment building or on a street corner. Pumping out the storm water is the most efficient way to remove it from your property. However, if you do not have access to a pumping station, then you will need to use a garden hose or a bucket of water to do the job.
If you are using a hose, make sure that the hose is long enough to reach the bottom of your drain and that it is not clogged with dirt or other debris. You should also ensure that you have enough water in your hose to cover the entire drain before you begin to pump it out.
How To Drain A Pool Connected To A Sewer
Draining your swimming pool onto the street, into storm drains and near waterways is illegal in many townships and municipalities across the country. You may be able to dechlorinate your pool water and use it to irrigate your lawn or garden, but you may only do so if it can be done without flooding your neighbors property or causing other problems, reports Chandler, Arizona. The best way to drain the pool is to empty it directly into the sanitary sewer line outside your home. The process is simple but can be time-consuming, depending on how fast you are able to pump the water.
Read Also: Best Stone For French Drain
Hook It Up: Install A Submersible Pump
Again, your regular pool pump isnt going to cut itits designed to suck in water, and once your pool drains even a little bit itll be sucking in air instead, which leads to a myriad of permanent damages. Its better to rent or buy a submersible pump, which isnt exactly cheap but wont break the bank.
Making sure that the power cord is long enough to reach from the bottom of your pool to your outlet, place the submersible pump on the floor in the center of the deep end. Its safer to avoid using an extension cord. The submersible pump will have a hose connected, and youll want to place the other end of that hose wherever youre draining out all that water. Make sure that it reaches all the way, or youll have thousands of gallons of water gone rouge to deal with.
Using Your Yard For Drain Your Pool
Avoid pool drainage directly onto your neighbors yards and driveways. While your pool may be big enough to handle the runoff, you dont want to cause a flood for others. Try using as much of your property as possible to absorb the pool water then, only send overflow water in more concentrated areas. Do remember not to let the water reach the street or any other public places because this would be considered a violation. When you choose to drain pool water into your yard, you agree to take responsibility for any damages caused by that decision. Remember, its always best to explore options such as re-routing the water before draining it anywhere near a neighbors yard or private property.
Recommended Reading: How To Clear Clogged Bathtub Drain
How Do You Drain A Pool With A Garden Hose
The garden hose needs to be put inside the port. As the water level increases, the pool will begin to fill. If you are using a pump, you will need to make sure that the pump is running at a steady rate.
You can use a timer to keep track of how much water is being pumped, or you can set the timer on your pump to automatically shut off when the pool is full.
Commercial Fats Oils And Grease
Restaurants play a major role in helping keep Scottsdales sewer system working properly. Reducing the amount of food waste that is put into the citys sewer helps reduce odors, avoid clogs or blockages and prevent costly repairs. Grease traps and interceptors are the best options to help keep the sewer system operating properly.
Grease traps are small devices located inside the kitchen, directly plumbed to the 3-compartment sink. They help trap food debris and grease that can mistakenly be washed into the sewer
Read Also: Can You Use Drano In Shower Drain
Important Considerations When Draining Your Pool
Completely draining the water from your swimming pool is simple, but there are some maintenance risks that come with it. Check out some considerations below before you proceed with it.
- Loss of Shape Of course, water helps in holding the shape of your pool. It might lose shape if the water is drained, so it is important to choose a day when the weather is good for draining. Do I have to winterize my pool is also a question often asked by pool owners.
- Molds A pool without water can be a homeground for molds, so once pool water is drained, make sure to take steps to prevent the development of molds on the liner. Molds usually grow due to storing the liner without completely drying it
- Sun Damage Water helps protect the liner of your pool. If the pool does not have water in it, the liner becomes prone to damage and warping caused by the suns UV rays.
What Is The Best Weather For Draining A Pool
‘It’s important to consider that the pressure around the pool is always greater in the winter, after heavy rainfall,’ Verdun says.
So, if you’re draining your inground pool, pick a day that falls within a dry week, ideally not in the colder months.
Bear in mind that high temperatures can also damage your pool liner, however, if it’s exposed for too long. Swim University recommends waiting until the outside temperature is 85°F or lower.
Wait for a dry spell to drain your pool
You May Like: Commercial Kitchen Floor Drain Requirements
Open The Hydrostatic Pressure Relief Valves
First, what the heck are these things? You came here to learn how to drain a pool, and now theres all this technobabble. Relax. Thats a really long name for a pretty simple but important feature.
If you look at your pools floor, youll see at least one, but probably a few, white rings embedded in the floor. Theyre plastered in place when the pool is built, but under that plaster, theyre threaded onto a slotted pipe.
This pipe runs along the floor of the pool, and then terminates into a gravel pit under the pool floor, which is also put in place when the pool is built. The purpose of these valves is to allow groundwater to come up into the pool if and when its drained.
If water accumulated under the pool with nowhere to go, it would create hydrostatic pressure, which is what would make the pool pop. These valves help relieve that pressure, thereby preventing popping.
Important: Do not open any hydrostatic pressure relief valves until the pool is mostly drained. When the pool gets to that point, you may only need to open one valve to relieve any built-up pressure. The valve in the center of the deep end is best. But if you live in an area with a high water table, you may want to open two valves to be on the safe side.
To open a relief valve, use a hammer and chisel to break and remove the plaster inside the cap, which will reveal the threaded plug. Use large pliers to twist the plug counterclockwise and remove it.
How To Drain Your Inground Pool
Draining your inground pool can be an extremely risky endeavor, and it is something we recommend only as a last resort. Draining an inground pool is more dangerous than draining an above ground pool because the ground can cave in, destroying the walls. Any damage that occurs to an inground pool is going to be many times more expensive to repair than that of an above ground pool.
We recommend only draining pools that have a hydrostatic valve and calling a professional if you have any reservations about emptying the pool yourself.
You May Like: How To Get Rid Of Fruit Flies In The Drain
What Does A Sewer Cleanout Line Look Like
The cleanout is usually a 4-inch-diameter pipe with a screw cap that has a square knob or indentation on the top. It’s most likely going to be popping up from the ground outside your home between the foundation and the street. The cleanout might also be on the side of the home, closest to the bathroom.
How To Drain An In
Draining an in-ground pool is much more involved than draining an above-ground one.
Your in-ground pool may have two or three hydrostatic plugs. Removing all of them is best, but make the one in the deep end the priority. It will release that upward pressure the quickest, and you wont have to fight running groundwater from the other plugs. Using this method, you should be able to avoid pool pop. Just be sure to replace the hydrostatic plugs before refilling.
Recommended Reading: Kenmore Elite Washer Won’t Drain
Where To Drain Pool Water Everything You Need To Know
Whether youre planning to open your pool after a long winter season, replace old pool water, or close it for a few months, youll probably need to drain some of the water in your swimming pool at some point.
If so, then this is going to be an important article for you. We are going to discuss how and where to drain pool water so it doesnt end up damaging your lawn or other parts of your property.
If The Finish Needs To Be Cleaned
If your swimming pool goes years without being thoroughly scrubbed, itll catch up with you eventually. Yes, you should still be following a maintenance schedule using your skimmer net, pool brush, and vacuum, but the presence of TDS in the water will compound as time goes on, staining the finish.
Pool water can become high in metals or calcium, both of which will leave permanent reminders on the walls of the pool. In some cases, calcium deposits can even affect operation of your pool equipment. Thats a bill you can live without!
To fully remove surface stains, youll need to do an acid wash that requires an empty pool.
Don’t Miss: Drain Pump For Kenmore Elite Washer
Pick A Way To Drain The Pool
Some communities will allow you to drain your pool into the storm sewer but you might need a permit to do so. Officials might also ask you for water quality tests for pH and chlorine levels.
If your community doesnt allow homeowners to drain pool water into a storm sewer, youll have to either use your homes sewer clean out or try to use it to irrigate landscaping or grass. Your sewer clean out is usually a threaded cap that is three to four inches in diameter and typically located on the side of the house or the backyard. Some older homes have an in-wall sewer clean out, but its not recommended to use an in-wall sewer cleanout to drain a pool because of the risk of a water backup in the house.
How Do I Get The Last 2 Inches Of Water Out Of My Pool
use a wet vacuum to suck the stagnant water from the pool. The liquid should be swept into the drain. To get rid of any water that may have accumulated in the liner, flip the pool liner over on your property. Use a hose to drain the water from your pool. You can also use a garden hose if you dont have access to a vacuum.
Read Also: Tool To Get Something Out Of Drain
Drain Your Pool With A Submersible Pool Pump
A submersible pump is an affordable piece of pool equipment that offers a few uses. Not only is it helpful to remove water from melted snow on the top of a winter cover in the spring, but it can also help you remove water from your pool in preparation of winter.
What Is The Fastest Way To Drain An Inground Pool
The easiest way to lower the water level in a pool is to place the multiport valve into the waste position and roll out the backwash hose. To lower the level of the pool, backwash the filter if you have a slide.
from an In-ground Pool If your pool is located in an enclosed space, such as a basement or crawlspace, it may not be possible to remove the slide from the bottom. In this case, use the same method as described above for removing a filter.
However, if you do not have access to a drill press, or you are unable to drill a hole large enough to fit the valve, then you may need to use a hand drill. To drill the hole, place a small piece of wood or other material between the drill bit and the PVC pipe. The hole should be about 1/2 inch in diameter, and about 3/4 inch deep.
Then, using a 1-1/8-inch-diameter hole saw, drill through the wood to the other side. Be careful not to cut the pipe, as this may damage it.
Read Also: What Size Drain For Shower
If The Water Needs To Be Changed
At some point, the pool water will have to be changed out. Theres no way around this, but waiting until the last possible minute will save you the work and costs associated with draining and refilling a pool multiple times.
Issues like green pool water, high levels of calcium or cyanuric acid in the pool may require a partial drain to dilute the water. This isnt half as labor intensive or costly as a full drain. Additionally, you may still be able to rectify some of these water issues through the addition of certain chemicals.
After a few years though, the level of TDS in the water will be too high to ignore. Total dissolved solids are exactly what it sounds like theyre a record of everything the pool water has dissolved.
Measured in parts per million with a digital tester, TDS levels should become concerning around the 4000 ppm mark. For reference, drinking water has roughly 500 ppm, whereas ocean water is closer to 30,000 ppm.
Most water issues can be rectified by adding chemicals, but the only way to get rid of high levels of TDS is by doing a drain. Theres no way around this unfortunately, as the addition of more chemicals will only increase the already high TDS levels.
Things youll notice when TDS gets too high include an increased consumption of sanitizing chemicals, and the appearance of stains on the pools finish due to the oversaturation of minerals in the water. If high TDS levels arent dealt with, they can even cause the finish to erode.